In summary, in the actual debugging process of audio equipment for outdoor performances, it is necessary to carefully plan the stage audio debugging scheme and sound effects, and at the same time, it is necessary to analyze the possible force majeure factors. stage. When the performance stage is rich and requires a lot of sound effects, the tuning skills required by the tuner will also increase. Additionally, performing in stormy weather can cause serious damage to the sound and the sound effects presented. Therefore, it is necessary to formulate a corresponding preventive plan in the actual debugging process to fundamentally avoid the factors that affect the accuracy during the debugging process, so as to provide a good foundation for stage audio debugging and performance effects, so as to achieve a higher standard in the performance process.

Frequently asked questions about professional audio equipment

We all know that there are many kinds of professional audio equipment, but in the use of these equipment, it will also cause many problems. Let me introduce some problems that often occur in the use of equipment:

1. Console problem

The console is the control center for the lighting and sound system. Sometimes, if the high, mid, and low equalizers on the console are increased or decreased by the same amount, the sound system is not set up correctly. The system should be retuned to prevent over-adjustment of the console balancer. By paying attention to these details, many unnecessary problems can be avoided.

2. The wireless microphone signal is unstable

Usually most audio projects are equipped with wireless microphones, but due to improper installation and debugging, quite a few applications are not good, especially at the performance site, the working condition of wireless microphones will directly affect the performance quality, so this is a problem that cannot be ignored . Configuration: Minimize the operational separation between the transmitter and receiver, assuming that the frequency-tunable microphone can be switched to another channel.

3. The device shell is charged

The operation of the project requires electricity, so the electrification of the acoustic equipment enclosure often occurs during the commissioning of the acoustic equipment. While this is not a huge problem, it can compromise the safety of employees in severe cases. All, it cannot be ignored. There are two common reasons: one is the moist air caused by the internal insulation of the power supply or slight leakage; the other is the induced current generated when the shell absorbs the electromagnetic waves generated by accessories such as the power supply.